Bin liner size guide from bin dimensions

Estimate a flat liner’s width and length from a round or rectangular bin.

Your bin

Opening shape

Along the outside rim. From 0.01 to 1,000 centimetres.

Across the outside rim. From 0.01 to 1,000 centimetres.

Inside floor to rim. From 0.01 to 1,000 centimetres.

Allowance and results

Extra length for folding or tying. From 0 to 1,000 centimetres.

Result unit

Minimum flat width

50 cm

Rectangular bin, vertical walls, matching base and opening. Plain ungusseted bag.

Minimum flat width 50 cm. Minimum length 68.03 cm.

Liner dimensions

Minimum length

68.03 cm

Rim circumference

100 cm

Geometric estimate with your top allowance. Minimum dimensions round upwards.

Measure the opening and depth

This bin liner size guide estimates the flat width and length of a plain ungusseted bag from your bin’s dimensions. Measure the outside rim and the usable depth inside the bin.

For a round opening, measure the diameter across the widest part. For a rectangle, measure both sides. The model assumes straight vertical walls and a base with the same dimensions as the opening.

Bin capacity describes volume. Circumference measures the distance around the rim. Flat bag width is half the opening’s circumference when the bag’s two layers lie together.

A litre label alone cannot settle the liner size. A tall narrow bin and a short wide bin can hold the same volume while needing different bag dimensions.

Enter measurements in centimetres. The result-unit control changes only the displayed result, so your measurements stay unchanged. One inch equals 2.54 centimetres.

Calculate a liner example

The rectangular example needs a flat liner at least 50 cm wide and 68.03 cm long under the stated geometry. It uses a 30 × 20 cm opening, 40 cm depth and 10 cm top allowance.

Rectangular flat width equals opening length plus opening width. The length estimate adds bin depth, half the base diagonal and your top allowance. The diagonal is the square root of the two squared sides added together.

The example’s base diagonal is about 36.06 cm. Half adds about 18.03 cm beneath the bin depth. Adding the chosen 10 cm above the rim gives the displayed minimum length.

For a round bin, flat width equals diameter × pi ÷ 2. The length estimate is depth plus half the diameter plus top allowance.

The bottom allowance follows Inteplast’s liner sizing method. Its rectangular method uses half the base diagonal. Your top allowance replaces its fixed overhang.

Ten centimetres is the example’s allowance, not a tie-off guarantee. Increase it for the closure you intend to use. Zero allowance leaves no extra length above the rim.

The calculator keeps full precision internally. It rounds each minimum upwards to two decimal places below 100, or a whole unit from 100. Choose a product meeting both dimensions.

Compare the bag specification

Compare the estimate with the manufacturer’s actual width and usable length. A bin bag size guide based on capacity alone cannot establish how the opening or bottom is constructed.

Gusseted bags have folded panels. Their face width and expanded width describe different measurements, so a folded face-width figure cannot replace this tool’s ungusseted flat width.

Check where the maker measures length. Seams, handles and drawstring channels can reduce the usable depth or opening. Allow space for a thick rim, retaining ring or closure where needed.

The estimate assumes no stretch and adds no width for sliding over a rim. Choose extra width when the bag needs clearance, and compare the maker’s recommended bin dimensions.

A rounded rectangle, tapered bin or irregular base needs its maker’s fit information. Film thickness, load strength and puncture resistance are separate from dimensional fit.

Before buying a large pack, fit one liner over the rim and down to the floor. Check the intended closure with the bag filled to its normal level.