Bolt size guide by thread and dimensions

Match nominal bolt dimensions to a metric, UNC or UNF reference.

Thread reference

Thread family

Enter the declared nominal thread diameter.

Distance from one thread crest to the next.

Metric M3 to M24 at listed diameters; UNC and UNF from 1/4 to 1 inch. Enter diameter and lengths in mm.

Length comparison

Length convention

Measure between the selected drawing’s length arrows.

Use the same head convention for both lengths.

Nominal thread match

M8 × 1.25

Nominal dimensions only. Tolerance, grade and suitability need separate checks.

M8 × 1.25. Same length.

Compare the lengths

Bolt versus comparison

Same length

Bolt length
30 mm
Comparison length
30 mm

Measurement convention

LengthDiameterHead

Raised head: measure from under the head to the tip. Drawing is not to scale.

Separate diameter, pitch and length

A bolt size guide identifies a nominal thread by its diameter and pitch. Length describes how far the bolt extends from the selected measurement datum.

Measure across the shank or thread crests for diameter. Head width describes the head and cannot identify the thread size.

For a raised head, measure length from under the head to the tip. For a flat countersunk head, measure overall length. Choose the matching drawing before comparing lengths.

The Pro-Bolt measuring guide shows these different starting points. A raised countersunk or special head needs its own product drawing.

Metric pitch is the distance between adjacent thread crests in millimetres. Unified National Coarse (UNC) and Unified National Fine (UNF) references use threads per inch.

Enter diameter and both lengths in millimetres for every family. For an inch measurement, multiply by 25.4 before entering it.

Match the thread reference

The lookup requires the diameter and pitch to match the same row in the selected reference family. It does not round a nearby measurement into a match.

The lookup uses a subset of Aspen Fasteners’ unnumbered Inch & Metric Thread Standards reference. It includes listed metric pitches at M3, M4, M5, M6, M8, M10, M12, M14, M16, M18, M20, M22 and M24.

The UNC and UNF subset covers 1/4, 5/16, 3/8, 7/16, 1/2, 9/16, 5/8, 3/4, 7/8 and 1 inch nominal diameters. Numbered screw sizes and other thread families are outside this lookup.

In the fictional example, an 8 mm nominal diameter with a 1.25 mm pitch matches M8 × 1.25. Two 30 mm lengths give Same length.

Change only the pitch to 1.24 mm and the result is No exact match. The 30 mm length comparison still stands.

A 6.35 mm nominal diameter and 20 threads per inch match 1/4-20 UNC. That diameter with 28 threads per inch matches 1/4-28 UNF.

A measured external thread can be below its nominal diameter. This reference contains no tolerance limits, so a calliper reading alone does not prove a nominal match.

Use a thread gauge and the product’s dimensional drawing to establish the declared size. An unmatched entry can also belong to a thread outside the listed sizes.

Verify grade and application separately

A dimensional match establishes only the nominal row shown. It does not establish strength, material or whether a replacement suits the assembly.

This lookup calculates neither tightening torque nor load capacity. It does not assess thread tolerance, engagement or the mating part.

For a replacement, keep the original equipment specification and the fastener’s grade requirements alongside the dimensions. Safety-critical assemblies require their specified fastener and installation procedure.

Confirm the replacement’s product drawing uses the same length datum. A head that changes where the bolt seats can change the length needed for the assembly.