Dog crate size guide from measured dog dimensions

Compare dog measurements with Diggs Revol crate interiors and allowances.

Dog measurements

Reference: Diggs Revol home crates.

Measurement unit

Standing dog: nose tip to the base of the tail, excluding the tail.

Floor to head top, or the tallest upright ear tip if higher.

Depth taken from the usable interior height. Enter 0 for no bedding.

Length allowance

Height allowance: 2 inches, plus bedding depth.

Length and height match

3 interiors

Arithmetic comparison only. Check width and your dog’s actual movement.

3 interiors meet the length and height allowances.

Required interior space

Minimum length

70.16 cm

Minimum height

50.08 cm

Diggs Revol interiors

Interior dimensions and allowance comparison
SizeLength × width × heightLength checkHeight check
Small64.26 × 44.2 × 46.99 cm5.9 cm short3.09 cm short
Medium79.76 × 52.32 × 54.61 cmMeets lengthMeets height
Intermediate98.55 × 63.5 × 71.12 cmMeets lengthMeets height
Large108 × 71.12 × 76.2 cmMeets lengthMeets height

Matches: Medium, Intermediate and Large.

Measure for the selected crate chart

This dog crate size guide compares your measurements with Diggs Revol interiors. A match means the length and height meet the selected allowances.

  1. Stand your dog on level ground. Measure length from the nose tip to where the tail meets the spine, leaving the tail out.
  2. Measure height from the floor to the top of the head. Use the tallest ear tip when upright ears reach higher.
  3. Choose 2 or 4 inches of length allowance within Diggs’ stated range. The comparison adds 2 inches to height, plus your bedding depth.

The reference holds four Revol sizes. Diggs’ Revol sizing instructions distinguish internal measurements for the dog from external measurements for your room.

Match the exact model and version before buying. A size label or breed name cannot replace the measured interior.

Compare an interior-size example

The fictional example uses a dog 60 cm long and 45 cm tall, with no bedding. The 4-inch length allowance gives minimum dimensions of 70.16 cm long and 50.08 cm high.

Medium, Intermediate and Large pass both comparisons. Small fails both. The tool lists every matching interior and does not choose a breed-based size.

For a dog 20 inches long and 20 inches tall, a 2-inch length allowance requires 22 inches of length and 22 inches of height.

The Medium interior is 31.4 inches long but 21.5 inches high. It clears length and falls 0.5 inches short on height.

Bedding reduces headroom. Add its depth to the height requirement before comparing. The calculation uses unrounded measurements, with 1 inch equal to 2.54 cm.

“No supported match” means none of these four interiors clears both requirements. Compare another model’s declared interior measurements instead of choosing the nearest size label.

Check the animal and intended use

Length and height alone do not establish comfort or welfare. Width still matters, and the tool does not calculate a width requirement.

RSPCA Victoria’s crate guidance requires room for your dog to stand, turn around and lie down. Check those movements in the actual crate with its bedding.

A puppy’s current measurements describe its current size. Growth and adult-size estimates need a separate decision, and a divider changes the usable interior.

This home-crate comparison gives no airline acceptance or vehicle-restraint assessment. Air travel uses separate container rules and measurements.

Use IATA’s pet container guidance with your airline’s requirements when arranging a flight. A home-crate arithmetic match does not establish travel approval.