Envelope size guide by insert and envelope dimensions

Compare an insert and its clearance with envelope formats or measured internal dimensions.

Insert dimensions

Measurement unit
Fold

Half and thirds divide the longer entered side.

Added at both ends of each dimension.

Envelope reference

Compare with

Flat rectangular inserts. Either orientation. Results in centimetres.

Envelope comparison

3 listed matches

Two-dimensional fit only. Check the opening and the filled envelope.

3 listed matches.

Insert and allowance

Folded insert

14.8 × 10.5 cm

With clearance

15.4 × 11.1 cm

Reference comparison

Envelope dimensions and clearance comparison
EnvelopeDimensionsAllowance
C616.2 × 11.4 cmFits allowance
DL22 × 11 cmToo small
C522.9 × 16.2 cmFits allowance
C432.4 × 22.9 cmFits allowance

Measure the folded insert

This envelope size guide compares your insert and chosen clearance with the listed dimensions. A match identifies space in two dimensions.

Measure the insert in the state you will put into the envelope. For a greeting card, close the card before measuring its width and height.

If you measure an already-folded insert, choose No fold. If you enter an unfolded sheet, Half divides its longer side by two. Thirds divides that side by three.

The tool allows a quarter turn when comparing rectangles. It compares the longer side with the longer envelope dimension and the shorter sides together.

The fold calculation assumes equal panels without thickness. Measure the finished fold when overlapping panels or a thick stack change its dimensions.

Compare the envelope opening

Add twice your clearance per edge to each folded dimension. Both required dimensions must fit within the chosen reference.

The fictional card example starts at 148 × 105 mm with 3 mm per edge. It needs 154 × 111 mm, shown as 15.4 × 11.1 cm.

C6 is 162 × 114 mm. The card leaves 14 mm along the longer dimension and 9 mm along the shorter dimension before subtracting the allowance.

After the 6 mm total allowance on each dimension, C6 has 8 mm and 3 mm remaining. C5 and C4 also match. DL is too narrow for this allowance.

For a document example, enter an unfolded 210 × 297 mm sheet and choose Thirds. The folded insert is 210 × 99 mm.

With 3 mm per edge, that document needs 216 × 105 mm. DL is 220 × 110 mm, leaving 4 mm and 5 mm beyond the allowance.

The example’s 3 mm per edge is a user setting. Actual insertion depends on the product opening and contents.

The listed formats come from All Colour Envelopes’ size guide. Its measurement convention states that product dimensions are internal.

A format name alone does not establish another product’s usable interior. Choose Your interior to compare the actual usable measurements supplied for your envelope.

Check the opening as well as the interior. Seams and the flap shape can restrict insertion. Try a sample with the actual contents before ordering a batch.

Check thickness and mailing rules

A flat comparison does not allow for a stack of cards or a booklet’s spine. A gusset adds depth, which needs a separate product check.

Fill the envelope and confirm that its flap closes without straining the seams. Measure its packed thickness and outside dimensions, then weigh the complete item.

Australia Post’s domestic letter guidelines set separate limits for dimensions, thickness and weight. The thickness limit is 5 mm for small letters and 20 mm for large letters.

Those letter services require flexible contents. Rigid or inflexible items use parcel services. A matching C6, DL, C5 or C4 format does not establish a postal rate.