Moka pot size guide by declared cups and capacity

Compare a pot’s declared brew volume with the coffee you pour into each serving.

Your pot’s label

Use the brewed-coffee volume, not the boiler’s water capacity.

Use the cup label for that same pot model.

Your serving

Enter the coffee portion before adding milk or water.

Result unit

Enter volumes from 1 to 10,000 ml with up to two decimal places, and a cup count from 1 to 100.

Whole servings

4 servings

4 whole servings, with 10 ml left.

Volume comparison

Declared capacity

250 ml

Coffee per serving

60 ml

Per labelled cup

41.67 ml

Left after servings

10 ml

250 ml divided by 60 ml, rounded down. Declared label: 6 cups.

Assumes the entered brew volume is available to pour. Displayed volumes are rounded.

Read the moka cup label

A moka pot’s cup count describes the maker’s serving convention. Use the published brewed-coffee volume for that exact model to compare it with your own serving.

Reservoir capacity describes water in the lower boiler before brewing. Brew capacity describes the coffee collected above. Entering the reservoir volume as finished coffee overstates what you can pour.

Bialetti NZ’s Moka Express specifications list approximate brewed volumes of 130 ml for the 3-cup model and 250 ml for the 6-cup model. Those figures give about 43.33 ml and 41.67 ml per labelled cup respectively. A moka cup has no single conversion to a full mug.

The example opens on that 6-cup, 250 ml specification. Replace both entries with the matching cup count and brew volume for the pot you’re comparing. The per-cup result is an average from those entries.

Compare the intended serving

Divide the declared brew volume by the coffee volume you want in each serving. Round down to count complete servings. Subtract their combined volume from the declared brew to find the remainder.

For an illustrative 60 ml serving, 250 divided by 60 is about 4.17. The tool shows 4 whole servings. They use 240 ml and leave 10 ml. At 75 ml each, the same pot gives 3 whole servings and leaves 25 ml.

If your serving is larger than the declared brew, the result is 0 whole servings and the full brew remains. For a milk coffee or diluted coffee, enter only the coffee portion. Milk and added water do not increase the pot’s coffee output.

Enter both volumes in millilitres. The result-unit choice changes the displayed volumes only. US fluid ounces use the NIST volume conversion of approximately 29.57353 ml each. A very small result stays in millilitres when conversion would round it to zero.

The whole-serving count uses the entered volumes before display rounding. For volumes of 100 or more, the display shows whole units. Smaller volumes show up to two decimal places. The division line preserves your entered precision.

Use the pot as specified

This serving calculation does not set a boiler fill level or change how the pot operates. Brew according to the instructions for your exact model, even when you want fewer servings.

The Moka Express manual sets its water level at the lower edge of the safety valve and says to fill the funnel without pressing down the coffee. Do not alter those instructions to match the serving-count result.

Heat-source compatibility is a separate product specification. Bialetti’s Moka Express product page lists electric and gas hobs, with an induction plate required for induction use. A cup count alone does not establish hob compatibility.

The declared brew is a comparison reference. Bialetti NZ states that actual output depends on the water and coffee used. Measure the coffee you pour if you need to compare your own finished yield.