Screw size guide by diameter, thread and length

Match a declared machine screw diameter and pitch, then check its length convention.

Machine screw thread

Thread reference
Dimension units

Enter the declared nominal thread diameter.

Distance between neighbouring thread crests.

Metric M2 to M12 subset; UNC/UNF No. 4, 6, 8, 10 and 12 machine screws.

Head and length

Head convention

Use the starting point shown in the result.

Nominal thread match

M4 × 0.7

Nominal dimensions only. A match does not establish strength or interchangeability.

M4 × 0.7. Screw length 20 mm. Measure under the head to the tip.

Dimension comparison

Entered diameter
4 mm
Entered thread
0.7 mm pitch
Reference diameter
4 mm
Reference thread
0.7 mm pitch

Screw length

20 mm

Under the head to the tip.

Identify the screw and measurement method

A screw size guide matches a nominal thread diameter and pitch within a selected thread family. The head determines where to start measuring length.

This lookup covers machine screw threads. A wood screw needs its own product reference, even when its diameter resembles a machine screw.

For example, SPAX lists a 5 mm wood construction screw with a partial thread and a 4CUT point. Its 5 mm diameter does not identify it as an M5 machine thread.

Measure diameter across the thread crests. Keep head diameter separate. A calliper reading helps identify a candidate, but the measured diameter can differ from its nominal size.

For a raised head, measure from under the head to the tip. A flat countersunk screw includes the head in its overall length.

The Pro-Bolt measuring guide shows these starting points. Raised countersunk heads, grub screws and other special forms need their own dimensional drawings.

Metric pitch measures the distance between adjacent thread crests. Unified National Coarse (UNC) and Unified National Fine (UNF) threads use a count of threads per inch.

The unit choice applies to diameter, length and metric pitch. A UNC or UNF thread count remains threads per inch.

Match the declared dimensions

The lookup returns a match only when diameter and pitch identify the same listed nominal thread. It never selects a nearby size by rounding.

The bundled references come from Aspen Fasteners’ thread tables. The metric subset includes the printed pitches at M2, M2.5, M3, M4, M5, M6, M8, M10 and M12.

The numbered machine screw subset includes No. 4, No. 6, No. 8, No. 10 and No. 12 in UNC and UNF. Other sizes and thread families are outside this lookup.

In the fictional example, a 4 mm diameter and 0.7 mm pitch match M4 × 0.7. The 20 mm raised-head screw measures from under the head to the tip.

Change only the pitch to 0.69 mm and the tool shows No exact match. It keeps the entered length and its measurement convention visible.

A diameter of 0.112 inches with 40 threads per inch matches No. 4-40 UNC. With 48 threads per inch, that diameter matches No. 4-48 UNF.

The lookup converts inches with exactly 25.4 mm per inch, as defined by NIST’s length reference. It uses the table’s inch diameters without first rounding them to millimetres.

No exact match can mean an unlisted thread or a measurement that differs from the nominal reference. Use a thread gauge and the original product drawing to establish the declared size.

Confirm the actual fixing requirement

A dimensional match gives a thread reference. Choosing the actual fixing also requires the assembly’s load and substrate requirements.

Keep the specified material, grade and corrosion protection with the replacement dimensions. The lookup calculates neither load capacity nor tightening torque.

Head shape and drive are separate requirements. Two screws with the same thread can seat differently or need different tools.

Use the equipment or fixing manufacturer’s installation specification for thread engagement and torque. Safety-critical connections need the specified fastener and installation procedure.